Re: PATCH: Add --size-check=[error|warning]

[QUOTE] (H.J. Lu, did you drop me from the Cc: line?) * Jan Beulich <JBeulich@novell.com> wrote: >> Please make it so that it'll be a warning by default, and an error >> upon programmer request. Otherwise, for the very purpose ...

Message posted on the March 14th, 2011 - 6:10 AM ET

[PATCH] add some drop_caches documentation and info messsge

Hi, I would like to resurrect the following Dave's patch. The last time it has been posted was here https://lkml.org/lkml/2010/9/16/250 and there didn't seem to be any strong opposition. Kosaki was worried about possible excessive logging when ...

Message posted on the October 12th, 2012 - 09:00 am ET

[PATCH] Add commandline partitions for block devices v2

From: Ulf Hansson <ulf.hansson@stericsson.com> This adds an option to pass in block device partitions from the kernel cmdline. The rationale is that in embedded systems we sometimes have no standard partition table available: often due to ...

Message posted on the June 08th, 2010 - 07:40 am ET

[PATCH] add netdev led trigger

Add a netdev LED trigger for all Blinkenlights lovers... Originally taken from https://dev.openwrt.org/ticket/2776 Slightly updated for 2.6.24 by Mickey Lauer <mickey@openmoko.org> and for 2.6.36 by Eric Cooper <ecc@cmu.edu> ...

Message posted on the November 14th, 2010 - 04:30 pm ET

[PATCH] Add new linearfb driver

Split out linearfb from efifb so that boot loaders can program it as a simple linear framebuffer on non-EFI systems. This is useful for boot loaders with their own graphics drivers, e.g. GRUB 2, since in some cases on x86 they can set up non-VESA ...

Message posted on the August 25th, 2010 - 10:20 am ET

[RFC][PATCH] add dma_reserve_coherent_memory()/dma_free_reserved_memory() API

Hi all, struct device contains a member: struct dma_coherent_mem *dma_mem; to hold information for a piece of memory declared dma-coherent. Alternatively the same member could also be used to hold preallocated dma-coherent memory for latter ...

Message posted on the August 19th, 2010 - 11:30 am ET

[PATCH] Add security.selinux XATTR support for the UBIFS. Also fix couple of bugs in UBIFS extended attribute length calculation.

TESTING: Tested on MX28 based platforms using Micron MT29F2G08ABAEAH4 NAND With these change we are able to label UBIFS filesystem with security.selinux and run system with selinux enabled. Also ran integck test on UBI filesystem. Signed-off-by: ...

Message posted on the April 08th, 2012 - 09:50 am ET

[PATCH]Add device drivers (GbE, Packet Hub) for Topcliff

I developed the device drivers for Linux kernel 2.6.33-1. This time, I added the following drivers - GbE device - Packet HUB device Would you check them? The patch is uploaded to our WEB site in Sourceforge.net, Because the patch size was large. ...

Message posted on the April 16th, 2010 - 06:40 am ET

[PATCH] add Marvell 88W8688 support to libertas_sdio

This chip is for example used in the GuruPlug. This patch avoids the following error: libertas_sdio: failed to load firmware libertas_sdio: probe of mmc0:0001:1 failed with error -5 The fix is based on code in: ...

Message posted on the October 31st, 2012 - 05:30 pm ET

[PATCH] Add Winbond WB528SD Secure Digital (SD) card reader driver

From: Márton Németh <nm127@freemail.hu> This driver version of Winbond WB528SD can detect mechanical card presence only. The information is provided through sysfs. Signed-off-by: Márton Németh ...

Message posted on the January 21st, 2012 - 06:00 am ET

[PATCH] Add clocksource_register_hz/khz interface

Hey Thomas, I updated the patch docs and made the calls EXPORT_SYMBOL_GPL. However the need for both khz and hz is due to high freq clocksources like the TSC who's cycles/sec are close to the upper bound of a u32. Let me know if you (or anyone ...

Message posted on the May 05th, 2010 - 10:30 pm ET

[RFCv2][PATCH] add some drop_caches documentation and info messsge

This version tones down the BUG_ON(). I also noticed that the documentation fails to mention that more than just the inode and dentry slabs are shrunk. There is plenty of anecdotal evidence and a load of blog posts suggesting that using ...

Message posted on the September 16th, 2010 - 01:00 pm ET

[PATCH] Add munmap events to perf

This patch adds a new software event for munmaps. It will allows users to profile changes to address space. munmaps will be tracked with mmaps. Signed-off-by: Eric B Munson <ebmunson@us.ibm.com> Signed-off-by: Anton Blanchard ...

Message posted on the June 28th, 2010 - 02:10 pm ET

[PATCH] Add clocksource_register_hz/khz interface (take3)

Thomas, Ok, got rid of the code duplication. Let me know if you see any other issues with the interface. thanks -john How to pick good mult/shif pairs has always been difficult to describe to folks writing clocksource drivers, since it requires ...

Message posted on the May 07th, 2010 - 09:10 pm ET

		Advanced search
In

patch add size