[PATCH RESEND v5 1/2] ohci-nxp: Driver cleanup

April 26th, 2012 - 04:00 pm ET by Roland Stigge | Report spam
Cleanup for ohci-nxp.c:

* Cleanup of resource handling (mem and irq), use devm_request_and_ioremap()
* Use DMA_BIT_MASK()
* Don't remove __devinit
* Removed obsolete gpio.h include
* More consistent bit access symbols
* Removed unused extern declaration ocpi_enable()
* Added error handling on i2c_get_adapter()
* Whitespace cleanup

Signed-off-by: Roland Stigge <stigge@antcom.de>



Applies to v3.4-rc4

I separated these two patches out from the series of LPC32xx conversion since
most of the other patches are already integrated into the respective
subsystem's -next branches.

drivers/usb/host/ohci-nxp.c | 44 ++++++++++++++++++++++++++
1 file changed, 26 insertions(+), 18 deletions(-)

linux-2.6.orig/drivers/usb/host/ohci-nxp.c
+++ linux-2.6/drivers/usb/host/ohci-nxp.c
@@ -29,7 +29,6 @@

#include <mach/platform.h>
#include <mach/irqs.h>
-#include <asm/gpio.h>

#define USB_CONFIG_BASE 0x31020000
#define PWRMAN_BASE 0x40004000
@@ -38,7 +37,9 @@

/* USB_CTRL bit defines */
#define USB_SLAVE_HCLK_EN (1 << 24)
+#define USB_DEV_NEED_CLK_EN (1 << 22)
#define USB_HOST_NEED_CLK_EN (1 << 21)
+#define PAD_CONTROL_LAST_DRIVEN (1 << 19)

#define USB_OTG_CLK_CTRL IO_ADDRESS(USB_CONFIG_BASE + 0xFF4)
#define USB_OTG_CLK_STAT IO_ADDRESS(USB_CONFIG_BASE + 0xFF8)
@@ -117,7 +118,6 @@ static struct i2c_driver isp1301_driver;
static struct i2c_client *isp1301_i2c_client;

extern int usb_disabled(void);
-extern int ocpi_enable(void);

static struct clk *usb_clk;

@@ -220,7 +220,7 @@ static void isp1301_configure_lpc32xx(vo
ISP1301_I2C_INTERRUPT_RISING | ISP1301_I2C_REG_CLEAR_ADDR, ~0);

/* Enable usb_need_clk clock after transceiver is initialized */
- __raw_writel((__raw_readl(USB_CTRL) | (1 << 22)), USB_CTRL);
+ __raw_writel(__raw_readl(USB_CTRL) | USB_HOST_NEED_CLK_EN, USB_CTRL);

printk(KERN_INFO "ISP1301 Vendor ID : 0x%04x",
i2c_smbus_read_word_data(isp1301_i2c_client, 0x00));
@@ -374,9 +374,13 @@ static int __devinit usb_hcd_nxp_probe(s
const struct hc_driver *driver = &ohci_nxp_hc_driver;
struct i2c_adapter *i2c_adap;
struct i2c_board_info i2c_info;
+ struct resource *res;

int ret = 0, irq;

+ pdev->dev.coherent_dma_mask = DMA_BIT_MASK(32);
+ pdev->dev.dma_mask = &pdev->dev.coherent_dma_mask;
+
dev_dbg(&pdev->dev, "%s: " DRIVER_DESC " (nxp)", hcd_name);
if (usb_disabled()) {
err("USB is disabled");
@@ -384,16 +388,8 @@ static int __devinit usb_hcd_nxp_probe(s
goto out;
}

- if (pdev->num_resources != 2
- || pdev->resource[0].flags != IORESOURCE_MEM
- || pdev->resource[1].flags != IORESOURCE_IRQ) {
- err("Invalid resource configuration");
- ret = -ENODEV;
- goto out;
- }
-
/* Enable AHB slave USB clock, needed for further USB clock control */
- __raw_writel(USB_SLAVE_HCLK_EN | (1 << 19), USB_CTRL);
+ __raw_writel(USB_SLAVE_HCLK_EN | PAD_CONTROL_LAST_DRIVEN, USB_CTRL);

ret = i2c_add_driver(&isp1301_driver);
if (ret < 0) {
@@ -401,6 +397,11 @@ static int __devinit usb_hcd_nxp_probe(s
goto out;
}
i2c_adap = i2c_get_adapter(2);
+ if (!i2c_adap) {
+ err("failed on i2c_get_adapter");
+ goto out_i2c_driver;
+ }
+
memset(&i2c_info, 0, sizeof(struct i2c_board_info));
strlcpy(i2c_info.type, "isp1301_nxp", I2C_NAME_SIZE);
isp1301_i2c_client = i2c_new_probed_device(i2c_adap, &i2c_info,
@@ -442,7 +443,7 @@ static int __devinit usb_hcd_nxp_probe(s
while ((__raw_readl(USB_OTG_CLK_STAT) & USB_CLOCK_MASK) ! USB_CLOCK_MASK) ;

- hcd = usb_create_hcd (driver, &pdev->dev, dev_name(&pdev->dev));
+ hcd = usb_create_hcd(driver, &pdev->dev, dev_name(&pdev->dev));
if (!hcd) {
err("Failed to allocate HC buffer");
ret = -ENOMEM;
@@ -452,14 +453,21 @@ static int __devinit usb_hcd_nxp_probe(s
/* Set all USB bits in the Start Enable register */
nxp_set_usb_bits();

- hcd->rsrc_start = pdev->resource[0].start;
- hcd->rsrc_len = pdev->resource[0].end - pdev->resource[0].start + 1;
- if (!request_mem_region(hcd->rsrc_start, hcd->rsrc_len, hcd_name)) {
- dev_dbg(&pdev->dev, "request_mem_region failed");
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ if (!res) {
+ dev_err(&pdev->dev, "Failed to get MEM resource");
+ ret = -ENOMEM;
+ goto out4;
+ }
+
+ hcd->regs = devm_request_and_ioremap(&pdev->dev, res);
+ if (!hcd->regs) {
+ err("Failed to devm_request_and_ioremap");
ret = -ENOMEM;
goto out4;
}
- hcd->regs = (void __iomem *)pdev->resource[0].start;
+ hcd->rsrc_start = res->start;
+ hcd->rsrc_len = resource_size(res);

irq = platform_get_irq(pdev, 0);
if (irq < 0) {
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
email Follow the discussionReplies 1 replyReplies Make a reply

Replies

#1 Roland Stigge
April 26th, 2012 - 04:10 pm ET | Report spam
This patch adds device tree support to ohci-nxp.c

Signed-off-by: Roland Stigge



Applies to v3.4-rc4

I separated these two patches out from the series of LPC32xx conversion since
most of the other patches are already integrated into the respective
subsystem's -next branches.

Documentation/devicetree/bindings/usb/ohci-nxp.txt | 16 ++++++++++++++++
drivers/usb/host/ohci-nxp.c | 10 ++++++++++
2 files changed, 26 insertions(+)

/dev/null
+++ linux-2.6/Documentation/devicetree/bindings/usb/ohci-nxp.txt
@@ -0,0 +1,16 @@
+* OHCI controller, NXP ohci-nxp variant
+
+Required properties:
+- compatible: must be "nxp,ohci-nxp"
+- reg: physical base address of the controller and length of memory mapped
+ region.
+- interrupts: The OHCI interrupt
+
+Example (LPC32xx):
+
+ {
+ compatible = "nxp,ohci-nxp";
+ reg = <0x31020000 0x300>;
+ interrupt-parent = <&mic>;
+ interrupts = <0x3b 0>;
+ };
linux-2.6.orig/drivers/usb/host/ohci-nxp.c
+++ linux-2.6/drivers/usb/host/ohci-nxp.c
@@ -22,6 +22,7 @@
#include <linux/clk.h>
#include <linux/platform_device.h>
#include <linux/i2c.h>
+#include <linux/of.h>

#include <mach/hardware.h>
#include <asm/mach-types.h>
@@ -525,10 +526,19 @@ static int usb_hcd_nxp_remove(struct pla
/* work with hotplug and coldplug */
MODULE_ALIAS("platform:usb-ohci");

+#ifdef CONFIG_OF
+static const struct of_device_id usb_hcd_nxp_match[] = {
+ { .compatible = "nxp,ohci-nxp" },
+ {},
+};
+MODULE_DEVICE_TABLE(of, usb_hcd_nxp_match);
+#endif
+
static struct platform_driver usb_hcd_nxp_driver = {
.driver = {
.name = "usb-ohci",
.owner = THIS_MODULE,
+ .of_match_table = of_match_ptr(usb_hcd_nxp_match),
},
.probe = usb_hcd_nxp_probe,
.remove = usb_hcd_nxp_remove,
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

Similar topics